System 2000 universal LED dimming insert
Features
– Universal LED dimming insert for the switching and dimming of light bulbs, HV halogen lamps, Tronic transformers with halogen lamps,
dimmable inductive transformers with halogen or LED lamps, HV LED and compact fluorescent lamps.
– Automatic or manual setting of dimming principle according to load (leading or trailing edge).
– Display of the selected operating mode using LED.
– Bulb-saving switch-on.
– Switch-on brightness can be saved permanently.
– Minimum brightness can be set.
– Connecting auxiliary units is possible.
– Electronic short-circuit protection.
– Electronic excess-temperature protection.
– Operation with and without neutral conductor connection.
Technical data
Rated voltage: AC 230 V, 50/60 Hz
Standby: max. 0.5 W
Connected load
– LED lamps: typ. 3 to 100 W
– LED lamps:
– Compact fluorescent lamp: typ. 3 to 100 W
– Light bulbs: 20 to 420 W
– HV halogen lamps: 20 to 420 W
– Gira Tronic transformers: 20 to 420 W
– electronic transformer with NV-LED:
– Wound transformer: 20 to 420 VA
– Wound transformer with NV-LED:
Auxiliary units
– Non-illuminated mechanical buttons: unlimited
– Auxiliary insert, 2-wire: unlimited
– Auxiliary insert, 3-wire: 5
Cable length
– Auxiliary unit: max. 100 m
Installation depth: 28 mm
Connections
– Single-wire: max. 4 mm²
– Fine-wire without core jacket: max. 4 mm²
– Fine-wire with core jacket: max. 2.5 mm²
Ambient temperature: +5 °C to +45 °C
Notes
– In general, operating the dimmer without connecting a neutral conductor is possible, although some LED and CFLi light sources require the
neutral conductor connection to prevent flickering.
– For operation without a neutral conductor, the minimum load for light bulbs, HV halogen lamps, Gira Tronic transformers, and wound
transformers increases to 50 W.
– In combination with power boosters, do not hook up HV-LED or compact fluorescent lamps.
